Replacing a Speedheat thermostat with PS60 WiFi: a real installation
Can an older Speedheat thermostat be replaced with a modern WiFi thermostat? In this installation, the Pro-mat PS60 made that possible. The electric underfloor heating and existing 10 kΩ floor sensor were retained.
The aim: modern controls with WiFi
The customer wanted a modern thermostat and a daily heating programme. Replacing the heating in the floor was unnecessary in this case. We replaced the older digital Speedheat thermostat with a black PS60.
Before and after
The first photo shows the old digital thermostat. The second shows the black PS60 after installation. The white component to the left remained in place.
Before replacement

After replacement

Reusing the existing 10 kΩ floor sensor
A floor sensor is often already embedded in the floor. When replacing a thermostat, we therefore check whether the sensor is compatible with the new controller. The PS60 supports several floor sensor settings, allowing suitable existing sensors to be retained.
This installation had a 10 kΩ floor sensor. We reused it and set the PS60 to 10 kΩ. No new sensor needed to be installed in the floor.
A fixed schedule from 06:00 to 18:00
The customer wanted to use the heating more during the day, with their solar panels in mind. We set a fixed schedule from 06:00 to 18:00.
This is a fixed-time programme. It does not follow sunrise or sunset and does not automatically respond to surplus solar power. How much self-generated electricity is used depends on generation, heat demand and other electricity use at the time.
The result
After installation and configuration, the existing heating system works well with the new PS60. The customer now has modern WiFi controls and a daily programme, while keeping the existing heating and floor sensor.
Frequently asked questions
Does the PS60 work with every Speedheat system?
Compatibility must be assessed for each installation. The supply voltage, electrical load, existing controls and sensor characteristics must be suitable. This successful project does not mean that every Speedheat system can be converted without modifications.
Does the floor sensor always need replacing?
No. In this project, the existing 10 kΩ sensor was retained. For other systems, we first check the sensor type and whether its characteristics are supported.
Was the old thermostat broken?
The reason for replacement was the customer's wish for modern WiFi controls. This was an upgrade of the controls for an existing heating system.
Would you like to replace your thermostat?
Send us a photo of your current thermostat and the available installation details. We can assess whether the PS60 is suitable. Ask for personal advice or call +31 85 799 1194.
View the Pro-mat PS60 WiFi thermostat · Read about our installation service in Twente, the Netherlands